Worthog Instructions

---

 

- Step 1

Remove the existing cooler spigot and make sure the opening is 3/4 inches. Some filing or drilling may be required.

- Step 2

Remove the T assembly, nylon nut, stainless washer and 1 o-ring from the threaded valve.

- Step 3

Insert the threaded valve into the cooler opening.

- Step 4

On the inside of the cooler slip on the o-ring, stainless washer and thread on the nylon nut. Do not tighten the nut.

- Step 5

Hold the T assembly and turn the threaded valve into the T. Make sure that it is hand tight and then tighten the nylon nut by hand.

- Step 7

Using a wrench or pliers, tighten the nylon nut as much as possible.

- Step 8

Fill the cooler with water and check for leaks. If needed tighten the nut some more. NOTE: After the first use, check the nut for tightness again.